703 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7030ACM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7030ACM single-row angular contact ball bearing: 150 mm bore (d), 225 mm outside diameter (D), 35 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 150 mmD 225 mmB 35 mmCr 137 kNMass 4.80 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 150D 225B 35

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d150 mm
Outside diameter D225 mm
Width B35 mm
Mass4.80 kg
Catalogue dynamic load Cr137 kN
Catalogue static load Cor154 kN
Grease-lubricated speed1900 rpm
Oil-lubricated speed2800 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da213 mm
Abutment dimension da162 mm
Minimum chamfer r122.1 mm
Minimum chamfer r341.1 mm
Factor X0.42
Factor Y0.87
Factor Y00.38
Factor e0.68
Maximum fillet ra2 mm
Load centre dimension a61.2 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7030ACM?

The 7030ACM catalogue lists da min = 162 mm; Da max = 213 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7030ACM?

The listed values for 7030ACM are grease: 1900 rpm; oil: 2800 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7030ACM?

The catalogue reference mass for 7030ACM is 4.80 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7030ACM angular contact ball bearing handle combined loads?

7030ACM (150 × 225 × 35 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Other Bearing Series with 150 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
61830MADeep Groove Ball Bearing150 × 190 × 20 mm

Compare alternative series sharing the same 150 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7030ACM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top