722 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7220CM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7220CM single-row angular contact ball bearing: 100 mm bore (d), 180 mm outside diameter (D), 34 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 100 mmD 180 mmB 34 mmCr 120 kNMass 3.71 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 100D 180B 34

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d100 mm
Outside diameter D180 mm
Width B34 mm
Mass3.71 kg
Catalogue dynamic load Cr120 kN
Catalogue static load Cor136 kN
Grease-lubricated speed3000 rpm
Oil-lubricated speed4000 rpm
Mounting dimensions & additional parameters (6)
Abutment dimension Da168 mm
Abutment dimension da112 mm
Minimum chamfer r122.1 mm
Minimum chamfer r341.1 mm
Maximum fillet ra2 mm
Load centre dimension a35.8 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7220CM?

The 7220CM catalogue lists da min = 112 mm; Da max = 168 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7220CM?

The listed values for 7220CM are grease: 3000 rpm; oil: 4000 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7220CM?

The catalogue reference mass for 7220CM is 3.71 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7220CM angular contact ball bearing handle combined loads?

7220CM (100 × 180 × 34 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7220CM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top