722 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7226CM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7226CM single-row angular contact ball bearing: 130 mm bore (d), 230 mm outside diameter (D), 40 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 130 mmD 230 mmB 40 mmCr 165 kNMass 7.28 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 130D 230B 40

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d130 mm
Outside diameter D230 mm
Width B40 mm
Mass7.28 kg
Catalogue dynamic load Cr165 kN
Catalogue static load Cor210 kN
Grease-lubricated speed1900 rpm
Oil-lubricated speed2800 rpm
Mounting dimensions & additional parameters (6)
Abutment dimension Da216 mm
Abutment dimension da144 mm
Minimum chamfer r123 mm
Minimum chamfer r341.1 mm
Maximum fillet ra2.5 mm
Load centre dimension a44.1 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7226CM?

The 7226CM catalogue lists da min = 144 mm; Da max = 216 mm; ra max = 2.5 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7226CM?

The listed values for 7226CM are grease: 1900 rpm; oil: 2800 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7226CM?

The catalogue reference mass for 7226CM is 7.28 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7226CM angular contact ball bearing handle combined loads?

7226CM (130 × 230 × 40 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7226CM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top