732 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7328BM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7328BM single-row angular contact ball bearing: 140 mm bore (d), 300 mm outside diameter (D), 62 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 140 mmD 300 mmB 62 mmCr 212 kNMass 21.6 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 140D 300B 62

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d140 mm
Outside diameter D300 mm
Width B62 mm
Mass21.6 kg
Catalogue dynamic load Cr212 kN
Catalogue static load Cor310 kN
Grease-lubricated speed1700 rpm
Oil-lubricated speed2400 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da282 mm
Abutment dimension da158 mm
Minimum chamfer r124 mm
Minimum chamfer r341.5 mm
Factor X0.35
Factor Y0.57
Factor Y00.26
Factor e1.14
Maximum fillet ra3 mm
Load centre dimension a123.3 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7328BM?

The 7328BM catalogue lists da min = 158 mm; Da max = 282 mm; ra max = 3 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7328BM?

The listed values for 7328BM are grease: 1700 rpm; oil: 2400 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7328BM?

The catalogue reference mass for 7328BM is 21.6 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7328BM angular contact ball bearing handle combined loads?

7328BM (140 × 300 × 62 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Other Bearing Series with 140 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
61828MDeep Groove Ball Bearing140 × 175 × 18 mm

Compare alternative series sharing the same 140 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7328BM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top