703 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7034ACM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7034ACM single-row angular contact ball bearing: 170 mm bore (d), 260 mm outside diameter (D), 42 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 170 mmD 260 mmB 42 mmCr 186 kNMass 8.27 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 170D 260B 42

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d170 mm
Outside diameter D260 mm
Width B42 mm
Mass8.27 kg
Catalogue dynamic load Cr186 kN
Catalogue static load Cor214 kN
Grease-lubricated speed1700 rpm
Oil-lubricated speed2400 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da248 mm
Abutment dimension da182 mm
Minimum chamfer r122.1 mm
Minimum chamfer r341.1 mm
Factor X0.42
Factor Y0.87
Factor Y00.38
Factor e0.68
Maximum fillet ra2 mm
Load centre dimension a71.1 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7034ACM?

The 7034ACM catalogue lists da min = 182 mm; Da max = 248 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7034ACM?

The listed values for 7034ACM are grease: 1700 rpm; oil: 2400 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7034ACM?

The catalogue reference mass for 7034ACM is 8.27 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7034ACM angular contact ball bearing handle combined loads?

7034ACM (170 × 260 × 42 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Other Bearing Series with 170 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
61834MDeep Groove Ball Bearing170 × 215 × 22 mm
NU3834MCylindrical Roller Bearing170 × 215 × 34 mm

Compare alternative series sharing the same 170 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7034ACM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top