703 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7038ACM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7038ACM single-row angular contact ball bearing: 190 mm bore (d), 290 mm outside diameter (D), 46 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 190 mmD 290 mmB 46 mmCr 176 kNMass 11.3 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 190D 290B 46

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d190 mm
Outside diameter D290 mm
Width B46 mm
Mass11.3 kg
Catalogue dynamic load Cr176 kN
Catalogue static load Cor265 kN
Grease-lubricated speed1600 rpm
Oil-lubricated speed2200 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da278 mm
Abutment dimension da202 mm
Minimum chamfer r122.1 mm
Minimum chamfer r341.1 mm
Factor X0.42
Factor Y0.87
Factor Y00.38
Factor e0.68
Maximum fillet ra2 mm
Load centre dimension a79.0 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7038ACM?

The 7038ACM catalogue lists da min = 202 mm; Da max = 278 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7038ACM?

The listed values for 7038ACM are grease: 1600 rpm; oil: 2200 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7038ACM?

The catalogue reference mass for 7038ACM is 11.3 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7038ACM angular contact ball bearing handle combined loads?

7038ACM (190 × 290 × 46 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Other Bearing Series with 190 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
NU2838MCylindrical Roller Bearing190 × 240 × 30 mm

Compare alternative series sharing the same 190 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7038ACM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top