723 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7232ACM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7232ACM single-row angular contact ball bearing: 160 mm bore (d), 290 mm outside diameter (D), 48 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 160 mmD 290 mmB 48 mmCr 263 kNMass 14.5 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 160D 290B 48

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d160 mm
Outside diameter D290 mm
Width B48 mm
Mass14.5 kg
Catalogue dynamic load Cr263 kN
Catalogue static load Cor305 kN
Grease-lubricated speed1600 rpm
Oil-lubricated speed2200 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da276 mm
Abutment dimension da174 mm
Minimum chamfer r123 mm
Minimum chamfer r341.1 mm
Factor X0.42
Factor Y0.87
Factor Y00.38
Factor e0.68
Maximum fillet ra2.5 mm
Load centre dimension a76.5 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7232ACM?

The 7232ACM catalogue lists da min = 174 mm; Da max = 276 mm; ra max = 2.5 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7232ACM?

The listed values for 7232ACM are grease: 1600 rpm; oil: 2200 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7232ACM?

The catalogue reference mass for 7232ACM is 14.5 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7232ACM angular contact ball bearing handle combined loads?

7232ACM (160 × 290 × 48 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Other Bearing Series with 160 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
61832MADeep Groove Ball Bearing160 × 200 × 20 mm

Compare alternative series sharing the same 160 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7232ACM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top