723 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7234CM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7234CM single-row angular contact ball bearing: 170 mm bore (d), 310 mm outside diameter (D), 52 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 170 mmD 310 mmB 52 mmCr 295 kNMass 18.3 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 170D 310B 52

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d170 mm
Outside diameter D310 mm
Width B52 mm
Mass18.3 kg
Catalogue dynamic load Cr295 kN
Catalogue static load Cor360 kN
Grease-lubricated speed1600 rpm
Oil-lubricated speed2200 rpm
Mounting dimensions & additional parameters (6)
Abutment dimension Da292 mm
Abutment dimension da188 mm
Minimum chamfer r124 mm
Minimum chamfer r341.5 mm
Maximum fillet ra3 mm
Load centre dimension a58.2 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7234CM?

The 7234CM catalogue lists da min = 188 mm; Da max = 292 mm; ra max = 3 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7234CM?

The listed values for 7234CM are grease: 1600 rpm; oil: 2200 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7234CM?

The catalogue reference mass for 7234CM is 18.3 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7234CM angular contact ball bearing handle combined loads?

7234CM (170 × 310 × 52 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Other Bearing Series with 170 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
61834MDeep Groove Ball Bearing170 × 215 × 22 mm
NU3834MCylindrical Roller Bearing170 × 215 × 34 mm

Compare alternative series sharing the same 170 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7234CM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top