723 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7238BM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7238BM single-row angular contact ball bearing: 190 mm bore (d), 340 mm outside diameter (D), 55 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 190 mmD 340 mmB 55 mmCr 284 kNMass 22.5 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 190D 340B 55

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d190 mm
Outside diameter D340 mm
Width B55 mm
Mass22.5 kg
Catalogue dynamic load Cr284 kN
Catalogue static load Cor375 kN
Grease-lubricated speed1400 rpm
Oil-lubricated speed1900 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da315 mm
Abutment dimension da217 mm
Minimum chamfer r124 mm
Minimum chamfer r341.5 mm
Factor X0.35
Factor Y0.57
Factor Y00.26
Factor e1.14
Maximum fillet ra3 mm
Load centre dimension a138.7 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7238BM?

The 7238BM catalogue lists da min = 217 mm; Da max = 315 mm; ra max = 3 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7238BM?

The listed values for 7238BM are grease: 1400 rpm; oil: 1900 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7238BM?

The catalogue reference mass for 7238BM is 22.5 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7238BM angular contact ball bearing handle combined loads?

7238BM (190 × 340 × 55 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Other Bearing Series with 190 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
NU2838MCylindrical Roller Bearing190 × 240 × 30 mm

Compare alternative series sharing the same 190 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7238BM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top