723 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7236ACM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7236ACM single-row angular contact ball bearing: 180 mm bore (d), 320 mm outside diameter (D), 52 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 180 mmD 320 mmB 52 mmCr 244 kNMass 18.7 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 180D 320B 52

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d180 mm
Outside diameter D320 mm
Width B52 mm
Mass18.7 kg
Catalogue dynamic load Cr244 kN
Catalogue static load Cor399 kN
Grease-lubricated speed1500 rpm
Oil-lubricated speed2000 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da302 mm
Abutment dimension da198 mm
Minimum chamfer r124 mm
Minimum chamfer r341.5 mm
Factor X0.42
Factor Y0.87
Factor Y00.38
Factor e0.68
Maximum fillet ra3 mm
Load centre dimension a84.3 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7236ACM?

The 7236ACM catalogue lists da min = 198 mm; Da max = 302 mm; ra max = 3 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7236ACM?

The listed values for 7236ACM are grease: 1500 rpm; oil: 2000 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7236ACM?

The catalogue reference mass for 7236ACM is 18.7 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7236ACM angular contact ball bearing handle combined loads?

7236ACM (180 × 320 × 52 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Other Bearing Series with 180 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
61836MADeep Groove Ball Bearing180 × 225 × 22 mm
NU3836MCylindrical Roller Bearing180 × 225 × 34 mm

Compare alternative series sharing the same 180 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7236ACM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top