732 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7320ACM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7320ACM single-row angular contact ball bearing: 100 mm bore (d), 215 mm outside diameter (D), 47 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 100 mmD 215 mmB 47 mmCr 164 kNMass 9.61 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 100D 215B 47

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d100 mm
Outside diameter D215 mm
Width B47 mm
Mass9.61 kg
Catalogue dynamic load Cr164 kN
Catalogue static load Cor199 kN
Grease-lubricated speed2600 rpm
Oil-lubricated speed3600 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da201 mm
Abutment dimension da114 mm
Minimum chamfer r123 mm
Minimum chamfer r341.1 mm
Factor X0.42
Factor Y0.87
Factor Y00.38
Factor e0.68
Maximum fillet ra2.5 mm
Load centre dimension a49.6 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7320ACM?

The 7320ACM catalogue lists da min = 114 mm; Da max = 201 mm; ra max = 2.5 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7320ACM?

The listed values for 7320ACM are grease: 2600 rpm; oil: 3600 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7320ACM?

The catalogue reference mass for 7320ACM is 9.61 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7320ACM angular contact ball bearing handle combined loads?

7320ACM (100 × 215 × 47 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7320ACM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top