732 SERIES · SINGLE-ROW ANGULAR CONTACT BALL BEARING

7322ACM Single-Row Angular Contact Ball Bearing Dimensions & Specifications

7322ACM single-row angular contact ball bearing: 110 mm bore (d), 240 mm outside diameter (D), 50 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 110 mmD 240 mmB 50 mmCr 184 kNMass 9.97 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Single-Row Angular Contact Ball Bearingd 110D 240B 50

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d110 mm
Outside diameter D240 mm
Width B50 mm
Mass9.97 kg
Catalogue dynamic load Cr184 kN
Catalogue static load Cor231 kN
Grease-lubricated speed2200 rpm
Oil-lubricated speed3200 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da226 mm
Abutment dimension da124 mm
Minimum chamfer r123 mm
Minimum chamfer r341.1 mm
Factor X0.42
Factor Y0.87
Factor Y00.38
Factor e0.68
Maximum fillet ra2.5 mm
Load centre dimension a65.8 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 7322ACM?

The 7322ACM catalogue lists da min = 124 mm; Da max = 226 mm; ra max = 2.5 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 7322ACM?

The listed values for 7322ACM are grease: 2200 rpm; oil: 3200 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 7322ACM?

The catalogue reference mass for 7322ACM is 9.97 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How does 7322ACM angular contact ball bearing handle combined loads?

7322ACM (110 × 240 × 50 mm) carries combined radial and axial loads along its contact angle. Single-row angular contact bearings carry unidirectional axial load and are normally mounted in opposed pairs (DB/DF) or tandem (DT). Verify contact angle and matched preload or clearance against engineering drawings.

Other Bearing Series with 110 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
61822Deep Groove Ball Bearing110 × 140 × 16 mm

Compare alternative series sharing the same 110 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 7322ACM

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top