294 SERIES · SPHERICAL ROLLER THRUST BEARING

29420 Spherical Roller Thrust Bearing Dimensions & Specifications

29420 spherical roller thrust bearing: 100 mm bore (d), 210 mm outside diameter (D), 67 mm height (H). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 100 mmD 210 mmH 67 mmCr 840 kNMass 10.5 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
d 100D 210H 67Spherical Roller Thrust Bearing (292/293/294)

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d100 mm
Outside diameter D210 mm
Total height H67 mm
Housing washer height C33 mm
Mass10.5 kg
Catalogue dynamic load Ca840 kN
Catalogue static load Coa2400 kN
Grease-lubricated speed1100 rpm
Oil-lubricated speed1600 rpm
Mounting dimensions & additional parameters (8)
Abutment dimension Da175 mm
Abutment dimension da150 mm
Minimum chamfer r123 mm
Diameter D1144 mm
Diameter d1185 mm
Maximum fillet ra2.5 mm
Offset S62 mm
Shaft washer height B43 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 29420?

The 29420 catalogue lists da min = 150 mm; Da max = 175 mm; ra max = 2.5 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 29420?

The listed values for 29420 are grease: 1100 rpm; oil: 1600 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 29420?

The catalogue reference mass for 29420 is 10.5 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

What lubrication and minimum load rules apply to 29420 spherical roller thrust bearing?

29420 (100 × 210 × 67 mm, total height H = 67 mm and housing washer height C = 33 mm) uses ISO 104 asymmetrical barrel rollers on a self-aligning spherical housing washer for high unidirectional axial loads. Oil lubrication is preferred under heavy load or continuous duty, and adequate minimum axial load must be maintained to prevent roller skidding.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 29420

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top