294 SERIES · SPHERICAL ROLLER THRUST BEARING

29468 Spherical Roller Thrust Bearing Dimensions & Specifications

29468 spherical roller thrust bearing: 340 mm bore (d), 620 mm outside diameter (D), 170 mm height (H). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 340 mmD 620 mmH 170 mmCr 4400 kNMass 218 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
d 340D 620H 170Spherical Roller Thrust Bearing (292/293/294)

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d340 mm
Outside diameter D620 mm
Total height H170 mm
Housing washer height C80 mm
Mass218 kg
Catalogue dynamic load Ca4400 kN
Catalogue static load Coa17400 kN
Grease-lubricated speed380 rpm
Oil-lubricated speed500 rpm
Mounting dimensions & additional parameters (8)
Abutment dimension Da530 mm
Abutment dimension da465 mm
Minimum chamfer r127.5 mm
Diameter D1449.5 mm
Diameter d1560 mm
Maximum fillet ra6 mm
Offset S201 mm
Shaft washer height B61 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 29468?

The 29468 catalogue lists da min = 465 mm; Da max = 530 mm; ra max = 6 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 29468?

The listed values for 29468 are grease: 380 rpm; oil: 500 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 29468?

The catalogue reference mass for 29468 is 218 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

What lubrication and minimum load rules apply to 29468 spherical roller thrust bearing?

29468 (340 × 620 × 170 mm, total height H = 170 mm and housing washer height C = 80 mm) uses ISO 104 asymmetrical barrel rollers on a self-aligning spherical housing washer for high unidirectional axial loads. Oil lubrication is preferred under heavy load or continuous duty, and adequate minimum axial load must be maintained to prevent roller skidding.

Other Bearing Series with 340 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
23868CA/W33Spherical Roller Bearing340 × 420 × 60 mm
61868Deep Groove Ball Bearing340 × 420 × 38 mm
NU2868MCylindrical Roller Bearing340 × 420 × 48 mm
NU3868MCylindrical Roller Bearing340 × 420 × 60 mm

Compare alternative series sharing the same 340 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 29468

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top