294 SERIES · SPHERICAL ROLLER THRUST BEARING

29488 Spherical Roller Thrust Bearing Dimensions & Specifications

29488 spherical roller thrust bearing: 440 mm bore (d), 780 mm outside diameter (D), 206 mm height (H). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 440 mmD 780 mmH 206 mmCr 7550 kNMass 410 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
d 440D 780H 206Spherical Roller Thrust Bearing (292/293/294)

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d440 mm
Outside diameter D780 mm
Total height H206 mm
Housing washer height C101 mm
Mass410 kg
Catalogue dynamic load Ca7550 kN
Catalogue static load Coa32000 kN
Oil-lubricated speed380 rpm
Mounting dimensions & additional parameters (8)
Abutment dimension Da670 mm
Abutment dimension da595 mm
Minimum chamfer r129.5 mm
Diameter D1577 mm
Diameter d1710 mm
Maximum fillet ra8 mm
Offset S260 mm
Shaft washer height B74 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for 29488?

The 29488 catalogue lists da min = 595 mm; Da max = 670 mm; ra max = 8 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for 29488?

The listed values for 29488 are oil: 380 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of 29488?

The catalogue reference mass for 29488 is 410 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

What lubrication and minimum load rules apply to 29488 spherical roller thrust bearing?

29488 (440 × 780 × 206 mm, total height H = 206 mm and housing washer height C = 101 mm) uses ISO 104 asymmetrical barrel rollers on a self-aligning spherical housing washer for high unidirectional axial loads. Oil lubrication is preferred under heavy load or continuous duty, and adequate minimum axial load must be maintained to prevent roller skidding.

Other Bearing Series with 440 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
61888Deep Groove Ball Bearing440 × 540 × 46 mm

Compare alternative series sharing the same 440 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for 29488

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top