QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1020MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1020MB four-point contact ball bearing: 100 mm bore (d), 149.5 mm outside diameter (D), 24 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 100 mmD 149.5 mmB 24 mmCr 106 kNMass 1.63 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 100D 149.5B 24

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d100 mm
Outside diameter D149.5 mm
Width B24 mm
Mass1.63 kg
Catalogue dynamic load Cr106 kN
Catalogue static load Cor134 kN
Grease-lubricated speed3200 rpm
Oil-lubricated speed4300 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da141 mm
Abutment dimension da109 mm
Minimum chamfer r121.5 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra1.5 mm
Load centre dimension a88 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1020MB?

The QJF1020MB catalogue lists da min = 109 mm; Da max = 141 mm; ra max = 1.5 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1020MB?

The listed values for QJF1020MB are grease: 3200 rpm; oil: 4300 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1020MB?

The catalogue reference mass for QJF1020MB is 1.63 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1020MB four-point contact ball bearing be loaded and mounted?

QJF1020MB (100 × 149.5 × 24 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1020MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top