QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1021MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1021MB four-point contact ball bearing: 105 mm bore (d), 160 mm outside diameter (D), 26 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 105 mmD 160 mmB 26 mmCr 124 kNMass 2.1 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 105D 160B 26

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d105 mm
Outside diameter D160 mm
Width B26 mm
Mass2.1 kg
Catalogue dynamic load Cr124 kN
Catalogue static load Cor156 kN
Grease-lubricated speed3000 rpm
Oil-lubricated speed4000 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da150 mm
Abutment dimension da115 mm
Minimum chamfer r122.0 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra2 mm
Load centre dimension a93 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1021MB?

The QJF1021MB catalogue lists da min = 115 mm; Da max = 150 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1021MB?

The listed values for QJF1021MB are grease: 3000 rpm; oil: 4000 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1021MB?

The catalogue reference mass for QJF1021MB is 2.1 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1021MB four-point contact ball bearing be loaded and mounted?

QJF1021MB (105 × 160 × 26 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1021MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top