QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1022MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1022MB four-point contact ball bearing: 110 mm bore (d), 170 mm outside diameter (D), 28 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 110 mmD 170 mmB 28 mmCr 146 kNMass 2.70 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 110D 170B 28

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d110 mm
Outside diameter D170 mm
Width B28 mm
Mass2.70 kg
Catalogue dynamic load Cr146 kN
Catalogue static load Cor186 kN
Grease-lubricated speed2800 rpm
Oil-lubricated speed3800 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da160 mm
Abutment dimension da120 mm
Minimum chamfer r122.0 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra2 mm
Load centre dimension a98 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1022MB?

The QJF1022MB catalogue lists da min = 120 mm; Da max = 160 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1022MB?

The listed values for QJF1022MB are grease: 2800 rpm; oil: 3800 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1022MB?

The catalogue reference mass for QJF1022MB is 2.70 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1022MB four-point contact ball bearing be loaded and mounted?

QJF1022MB (110 × 170 × 28 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1022MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top