QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1030 Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1030 four-point contact ball bearing: 150 mm bore (d), 225 mm outside diameter (D), 35 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 150 mmD 225 mmB 35 mmCr 220 kNMass 5.29 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 150D 225B 35

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d150 mm
Outside diameter D225 mm
Width B35 mm
Mass5.29 kg
Catalogue dynamic load Cr220 kN
Catalogue static load Cor300 kN
Grease-lubricated speed1900 rpm
Oil-lubricated speed2800 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da213 mm
Abutment dimension da162 mm
Minimum chamfer r122.1 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra2 mm
Load centre dimension a131 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Catalog Nominal Cross-References (Brand / Legacy Codes)

Envelope reference only · Verify interchangeability
Brand / Code TypeReference CodeCatalogue Source
Legacy Code116130ZQM Catalogue P.48

Notice: Cross-references above are listed from the ZQM Master Catalogue for nominal boundary-dimension lookup only. Internal clearance, cage design, roller profile, and load ratings vary by manufacturer; verify drawings before substitution.

Selection & installation

Which mounting dimensions are listed for QJF1030?

The QJF1030 catalogue lists da min = 162 mm; Da max = 213 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1030?

The listed values for QJF1030 are grease: 1900 rpm; oil: 2800 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1030?

The catalogue reference mass for QJF1030 is 5.29 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1030 four-point contact ball bearing be loaded and mounted?

QJF1030 (150 × 225 × 35 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1030

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top