QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1032MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1032MB four-point contact ball bearing: 160 mm bore (d), 240 mm outside diameter (D), 38 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 160 mmD 240 mmB 38 mmCr 250 kNMass 6.54 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 160D 240B 38

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d160 mm
Outside diameter D240 mm
Width B38 mm
Mass6.54 kg
Catalogue dynamic load Cr250 kN
Catalogue static load Cor355 kN
Grease-lubricated speed1800 rpm
Oil-lubricated speed2600 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da228 mm
Abutment dimension da172 mm
Minimum chamfer r122.1 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra2 mm
Load centre dimension a140 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1032MB?

The QJF1032MB catalogue lists da min = 172 mm; Da max = 228 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1032MB?

The listed values for QJF1032MB are grease: 1800 rpm; oil: 2600 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1032MB?

The catalogue reference mass for QJF1032MB is 6.54 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1032MB four-point contact ball bearing be loaded and mounted?

QJF1032MB (160 × 240 × 38 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1032MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top