QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1036MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1036MB four-point contact ball bearing: 180 mm bore (d), 280 mm outside diameter (D), 46 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 180 mmD 280 mmB 46 mmCr 340 kNMass 10.9 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 180D 280B 46

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d180 mm
Outside diameter D280 mm
Width B46 mm
Mass10.9 kg
Catalogue dynamic load Cr340 kN
Catalogue static load Cor510 kN
Grease-lubricated speed1600 rpm
Oil-lubricated speed2200 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da268 mm
Abutment dimension da192 mm
Minimum chamfer r122.1 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra2 mm
Load centre dimension a161 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1036MB?

The QJF1036MB catalogue lists da min = 192 mm; Da max = 268 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1036MB?

The listed values for QJF1036MB are grease: 1600 rpm; oil: 2200 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1036MB?

The catalogue reference mass for QJF1036MB is 10.9 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1036MB four-point contact ball bearing be loaded and mounted?

QJF1036MB (180 × 280 × 46 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1036MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top