QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1034MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1034MB four-point contact ball bearing: 170 mm bore (d), 260 mm outside diameter (D), 42 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 170 mmD 260 mmB 42 mmCr 290 kNMass 8.82 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 170D 260B 42

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d170 mm
Outside diameter D260 mm
Width B42 mm
Mass8.82 kg
Catalogue dynamic load Cr290 kN
Catalogue static load Cor410 kN
Grease-lubricated speed1700 rpm
Oil-lubricated speed2400 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da248 mm
Abutment dimension da182 mm
Minimum chamfer r122.1 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra2 mm
Load centre dimension a151 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1034MB?

The QJF1034MB catalogue lists da min = 182 mm; Da max = 248 mm; ra max = 2 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1034MB?

The listed values for QJF1034MB are grease: 1700 rpm; oil: 2400 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1034MB?

The catalogue reference mass for QJF1034MB is 8.82 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1034MB four-point contact ball bearing be loaded and mounted?

QJF1034MB (170 × 260 × 42 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1034MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top