QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1052X1MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1052X1MB four-point contact ball bearing: 260 mm bore (d), 399.5 mm outside diameter (D), 65 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 260 mmD 399.5 mmB 65 mmCr 550 kNMass 31.3 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 260D 399.5B 65

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d260 mm
Outside diameter D399.5 mm
Width B65 mm
Mass31.3 kg
Catalogue dynamic load Cr550 kN
Catalogue static load Cor1000 kN
Grease-lubricated speed1000 rpm
Oil-lubricated speed1500 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da383 mm
Abutment dimension da278 mm
Minimum chamfer r124.0 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra3 mm
Load centre dimension a231 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1052X1MB?

The QJF1052X1MB catalogue lists da min = 278 mm; Da max = 383 mm; ra max = 3 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1052X1MB?

The listed values for QJF1052X1MB are grease: 1000 rpm; oil: 1500 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1052X1MB?

The catalogue reference mass for QJF1052X1MB is 31.3 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1052X1MB four-point contact ball bearing be loaded and mounted?

QJF1052X1MB (260 × 399.5 × 65 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1052X1MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top