QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1048MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1048MB four-point contact ball bearing: 240 mm bore (d), 360 mm outside diameter (D), 56 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 240 mmD 360 mmB 56 mmCr 449 kNMass 20.9 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 240D 360B 56

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d240 mm
Outside diameter D360 mm
Width B56 mm
Mass20.9 kg
Catalogue dynamic load Cr449 kN
Catalogue static load Cor780 kN
Grease-lubricated speed1200 rpm
Oil-lubricated speed1700 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da346 mm
Abutment dimension da254 mm
Minimum chamfer r123.0 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra2.5 mm
Load centre dimension a210 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1048MB?

The QJF1048MB catalogue lists da min = 254 mm; Da max = 346 mm; ra max = 2.5 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1048MB?

The listed values for QJF1048MB are grease: 1200 rpm; oil: 1700 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1048MB?

The catalogue reference mass for QJF1048MB is 20.9 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1048MB four-point contact ball bearing be loaded and mounted?

QJF1048MB (240 × 360 × 56 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1048MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top