QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1060MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1060MB four-point contact ball bearing: 300 mm bore (d), 460 mm outside diameter (D), 74 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 300 mmD 460 mmB 74 mmCr 650 kNMass 48.5 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 300D 460B 74

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d300 mm
Outside diameter D460 mm
Width B74 mm
Mass48.5 kg
Catalogue dynamic load Cr650 kN
Catalogue static load Cor1340 kN
Grease-lubricated speed900 rpm
Oil-lubricated speed1300 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da442 mm
Abutment dimension da318 mm
Minimum chamfer r124.0 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra3 mm
Load centre dimension a266 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1060MB?

The QJF1060MB catalogue lists da min = 318 mm; Da max = 442 mm; ra max = 3 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1060MB?

The listed values for QJF1060MB are grease: 900 rpm; oil: 1300 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1060MB?

The catalogue reference mass for QJF1060MB is 48.5 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1060MB four-point contact ball bearing be loaded and mounted?

QJF1060MB (300 × 460 × 74 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Other Bearing Series with 300 mm Bore

Envelope reference only · Not direct interchange
Swipe horizontally to view full table
ModelTypeDimensions (d×D×B)
23860CA/W33Spherical Roller Bearing300 × 380 × 60 mm

Compare alternative series sharing the same 300 mm shaft bore diameter to review envelope dimensions (D × B) and ring/rib configurations. Shared bore diameter does not imply direct interchangeability.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1060MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top