QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1080MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1080MB four-point contact ball bearing: 400 mm bore (d), 600 mm outside diameter (D), 90 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 400 mmD 600 mmB 90 mmCr 904 kNMass 98.5 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 400D 600B 90

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d400 mm
Outside diameter D600 mm
Width B90 mm
Mass98.5 kg
Catalogue dynamic load Cr904 kN
Catalogue static load Cor2160 kN
Grease-lubricated speed700 rpm
Oil-lubricated speed950 rpm
Mounting dimensions & additional parameters (10)
Abutment dimension Da578 mm
Abutment dimension da422 mm
Minimum chamfer r125.0 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra4 mm
Load centre dimension a350 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1080MB?

The QJF1080MB catalogue lists da min = 422 mm; Da max = 578 mm; ra max = 4 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1080MB?

The listed values for QJF1080MB are grease: 700 rpm; oil: 950 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1080MB?

The catalogue reference mass for QJF1080MB is 98.5 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1080MB four-point contact ball bearing be loaded and mounted?

QJF1080MB (400 × 600 × 90 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1080MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top