QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING

QJF1076MB Four-Point Contact Ball Bearing Dimensions & Specifications

QJF1076MB four-point contact ball bearing: 380 mm bore (d), 560 mm outside diameter (D), 82 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.

d 380 mmD 560 mmB 82 mmCr 819 kNMass 75.0 kg

Nominal Cross-Section & Boundary Dimensions

Unit: mm · Schematic (not to scale)
Four-Point Contact Ball Bearing (Split Ring)d 380D 560B 82

Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.

Technical specifications

Source: ZQM Master Catalogue · Units: mm / kN / kg
Bore d380 mm
Outside diameter D560 mm
Width B82 mm
Mass75.0 kg
Catalogue dynamic load Cr819 kN
Catalogue static load Cor1900 kN
Grease-lubricated speed750 rpm
Oil-lubricated speed1000 rpm
Mounting dimensions & additional parameters (9)
Abutment dimension Da538 mm
Abutment dimension da402 mm
Minimum chamfer r125.0 mm
Factor X0.6
Factor Y00.58
Factor Y10.66
Factor Y21.07
Factor e0.95
Maximum fillet ra4 mm

Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.

Selection & installation

Which mounting dimensions are listed for QJF1076MB?

The QJF1076MB catalogue lists da min = 402 mm; Da max = 538 mm; ra max = 4 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.

What speed values are available for QJF1076MB?

The listed values for QJF1076MB are grease: 750 rpm; oil: 1000 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.

What is the reference mass of QJF1076MB?

The catalogue reference mass for QJF1076MB is 75.0 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.

How should QJF1076MB four-point contact ball bearing be loaded and mounted?

QJF1076MB (380 × 560 × 82 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.

Related ZQM Products & Engineering Guides

DIRECT FACTORY SOURCING

Request a Quote for QJF1076MB

Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

Scroll to Top