QJF10 SERIES · FOUR-POINT CONTACT BALL BEARING
QJF1092MB Four-Point Contact Ball Bearing Dimensions & Specifications
QJF1092MB four-point contact ball bearing: 460 mm bore (d), 680 mm outside diameter (D), 100 mm width (B). Review the available technical values below. Matching dimensions alone do not confirm interchangeability between designations or suffixes.
Nominal Cross-Section & Boundary Dimensions
Unit: mm · Schematic (not to scale)Schematic cross-section illustrating this bearing family with nominal catalog dimensions for this designation. Verify exact chamfers, cage geometry, and lubrication grooves against engineering drawings. Note: Specific split-ring configuration (inner vs. outer ring) for QJF designations is confirmed per engineering drawing.
| Bore d | 460 mm |
|---|---|
| Outside diameter D | 680 mm |
| Width B | 100 mm |
| Mass | 132 kg |
| Catalogue dynamic load Cr | 1040 kN |
| Catalogue static load Cor | 2650 kN |
| Grease-lubricated speed | 600 rpm |
| Oil-lubricated speed | 800 rpm |
Mounting dimensions & additional parameters (10)
| Abutment dimension Da | 652 mm |
|---|---|
| Abutment dimension da | 488 mm |
| Minimum chamfer r12 | 6.0 mm |
| Factor X | 0.6 |
| Factor Y0 | 0.58 |
| Factor Y1 | 0.66 |
| Factor Y2 | 1.07 |
| Factor e | 0.95 |
| Maximum fillet ra | 5 mm |
| Load centre dimension a | 399 mm |
Fields without confirmed values are omitted. Final supply configuration and application suitability require technical confirmation.
Catalog Nominal Cross-References (Brand / Legacy Codes)
Envelope reference only · Verify interchangeability| Brand / Code Type | Reference Code | Catalogue Source |
|---|---|---|
| Legacy Code | 116192 | ZQM Catalogue P.53 |
Notice: Cross-references above are listed from the ZQM Master Catalogue for nominal boundary-dimension lookup only. Internal clearance, cage design, roller profile, and load ratings vary by manufacturer; verify drawings before substitution.
Selection & installation
Which mounting dimensions are listed for QJF1092MB?
The QJF1092MB catalogue lists da min = 488 mm; Da max = 652 mm; ra max = 5 mm. Check these symbols against the bearing drawing and the shaft/housing shoulders; they are not shaft or housing fit tolerances.
What speed values are available for QJF1092MB?
The listed values for QJF1092MB are grease: 600 rpm; oil: 800 rpm. These catalogue references do not determine a safe operating speed on their own. Confirm load, clearance, lubrication and heat conditions for the application.
What is the reference mass of QJF1092MB?
The catalogue reference mass for QJF1092MB is 132 kg. Confirm the supplied assembly and packed shipment weight separately when planning handling or transport.
How should QJF1092MB four-point contact ball bearing be loaded and mounted?
QJF1092MB (460 × 680 × 100 mm) is designed for pure axial or predominantly axial bidirectional loads. When paired with a cylindrical roller bearing strictly as an axial locating unit, provide radial clearance between the outer ring and housing bore so it carries no radial load. Confirm specific split-ring configuration (inner vs. outer ring) for this QJF designation per drawing.
Related ZQM Products & Engineering Guides
Featured Stock & Production Models
Technical Guides & Series
DIRECT FACTORY SOURCING
Request a Quote for QJF1092MB
Share your required quantity, clearance (CN/C3/C4), and destination with ZQM Bearings. Mixed-model trial lots and OEM drawings welcome.

